en

Square bale wrapper without bale pick-up 
G3010 Q Standard | Square bale wrapper

 

The G3010 Q Standard is distinguished by its robust design as well as its low working height. The wide, continuous belt guarantees uniform wrapping of each and every bale - even if it is misshapen. The wrapper is equipped with the STANDARD program control.

Highlights

The G3010 Q Standard packages square and round bales in an equally clean and air-tight manner.

SECURE BALE GUIDING

The rotating rollers arranged on both sides are connected to each other with tie rods. This produces a controlled force, which in conjuntion with the belt, generates a clamping effect on the bales. The wrapper is able to guide the bale securely even with rectangular bale dimensions. A quick adjustment can adapt the belt length to different bale dimensions.

The user-friendly STANDARD program control with wireless operation

CONTROL STANDARD

A genuine highlight is the user-friendly and easy-to-use program control STANDARD with wireless operation.

The continuous bale conveyor belt guarantees uniform wrapping of each and every bale.

Continuous belt

The wide, continuous belt guarantees uniform wrapping of each and every bale - even if it is misshapen.

The feed rate shut-off valve provides for an accurate overlap of the film.

FEED RATE SHUT-OFF VALVE

This ensures that the film will overlap accurately for rectangular bales.

8.2 kW Honda gasoline engine including battery, generator and electric starter as well as hydraulic system

MOTOR

An 8.2 kW gasoline engine including battery, generator and electric starter as well as hydraulic system is available as an option.

Basic model

Single wrapping arm

Hydraulically tilting wrapping table with mechanical belt length adjustment

This ensures that the film will overlap accurately for rectangular bales

Bale deposit to the left and the right

Combined film stretching unit 500 mm and 750 mm (20” and 30”)

Automatic film cutting and holding system

Wide, continuous belt with belt guide and 2 bale guide rollers

Three-point linkage Cat. II

Work lights

The cycles "wrapping process" and "film-holding and cutting" start automatically, while “bale drop” starts at the push of a button.

Technical data (basic model)

Weight:850 kg (1900 lbs)
Length:2,705 mm (8’ 11”)
Width:1,720 mm (5’ 8”)
Height:2,760 mm (9’)
For all bale dimensions:

up to 1.20 x 1.40 m (up to 48” x 56”)

Bale length:up to 1.60 m (up to 63”)
Round bale diameter:0.90 - 1.50 m (36” – 60”)
Oil requirement:

starting at 20 l/min at max. 190 bar

Bale weight round / squaremax 1,800 / 1,000 kg (max. 4,000 / 2,200 lbs)

 

Required connections

1 pressure connection and 1 depressurized return for the supply of the wrapper

3-pin power outlet for the electrical supply including direct supply line to the battery (cable cross-section 2x6 mm²)

 

Additional equipment

The execution of all work cycles is fully automatic

Only in combination with fully automatic program control PROFI

Required connection: 3-pin power outlet for the electrical supply of the hand-held terminal
(12 V / 10 A)

Stops the wrapping process if film tears or runs out

Additional bale guide roller

Required connection: 7-pin power outlet for the entire lighting system (excluding work lights)

Including a 4 kW electric motor with pump, return filter and 30 L hydraulic oil tank

Including gearbox with pump, slip-on tractor PTO drive shaft, return filter and 30 L hydraulic oil tank

8.2 kW gasoline engine with battery, electric starter, return filter and 30 l hydraulic oil tank

Battery supply cable 5.3 meters (17 ft) 2x6 mm² with 3-pin power outlet

FacebookYoutubeInstagram Contact now