Three point square bale wrapper
G3010 Q | Square bale wrapper
The G3010 Q three point square bale is distinguished by its robust design as well as its low working height. The wide, continuous belt guarantees uniform wrapping of each and every bale - even if it is misshapen. The three point square bale wrapper is equipped with the STANDARD program control.
Highlights
Secure Bale Guiding
The rotating rollers arranged on both sides are connected to each other with tie rods. This produces a controlled force, which in conjuntion with the belt, generates a clamping effect on the bales. The wrapper is able to guide the bale securely even with rectangular bale dimensions. A quick adjustment can adapt the belt length to different bale dimensions.
Control STANDARD
A genuine highlight is the user-friendly and easy-to-use program control STANDARD with wireless operation.
Continuous belt
The wide, continuous belt guarantees uniform wrapping of each and every bale - even if it is misshapen.
Feed Rate Shut-off Valve
This ensures that the film will overlap accurately for rectangular bales.
Motor
An 8.2 kW gasoline engine including battery, generator and electric starter as well as hydraulic system is available as an option.
Hydraulic Bale Pick-up
The G3010 Q can be optionally equipped with a hydraulic bale pick-up for square and round bales. The bales are picked up on the right against the direction of travel.
Basic model
This ensures that the film will overlap accurately for rectangular bales
The cycles “wrapping process” and “film-holding and cutting” start automatically, while “bale drop” starts at the push of a button
Technical data (basic model)
| Weight: | 1,130 kg (2,490 lbs) |
| Length: | 2,705 mm (8’ 11”) |
| Width: | 1,720 mm (5’ 8”) |
| Height: | 2,760 mm (9’) |
| For all bale dimensions: | up to 1.20 x 1.40 m (up to 48” x 56”) |
| Bale length: | up to 1.60 m (up to 63”) |
| Round bale diameter: | 0.90 - 1.50 m (36” – 60”) |
| Oil requirement: | starting at 20 l/min (5 gpm) at max. 190 bar |
| Bale weight round / square | max 1,800 / 1,000 kg (max. 4,000 / 2,200 lbs) |
Required connections
1 pressure connection and one depressurized return for the supply of the wrapper (not applicable for PTO drive shaft) |
3-pin power outlet for the electrical supply including direct supply line to the battery (cable cross-section 2x6 mm²) |
Additional equipment
The execution of all work cycles is fully automatic
Only in combination with fully automatic program control PROFI
Required connection: 3-pin power outlet for the electrical supply of the hand-held terminal (12 V / 10 A)
Bale pick-up on the right against the direction of travel
Bale deposit on the left
Width altered to 1,820 mm
Stops the wrapping process if film tears or runs out
Required connection: 7-pin power outlet for the entire lighting system (excluding work lights)
without hydraulic oil) – tractor operation still possible
5 hp electric motor, return filter and 8 gal hydraulic oil tank, fully assembled
Required connection for electric motor: 400 V / 50 Hz, CEE 16 A, protection class IP55
(without hydraulic oil)
Including gearbox with hydraulic pump, slip-on tractor PTO drive shaft, return filter and 30 l hydraulic oil tank
(without hydraulic oil) – tractor operation still possible 11 hp gasoline engine with battery, electric starter, return filter and 8 gal hydraulic oil tank
